
Wiring and electrical panel
The condition of cables, connections, junction boxes and protective devices.
Learn more →Determining technical condition and the causes of short circuits, overheating, melting and damage after water ingress. Specialist opinions, report reviews and materials for court.
Prepare diagrams, records, the design and a description of the fault. Agree on access and the necessary safety conditions before the inspection.
Choose questions for the expert ↗Typical scenario
Suppose the circuit labels in a distribution board do not match the wiring diagram supplied after renovation. The contractor calls it a documentation issue, while the customer wants to know whether the installation itself also differs.
Typical scenario
If a motor starts overheating or tripping after control equipment is replaced, timing alone does not establish the new devices as the cause. The previous and actual configurations, operating conditions and sequence of interventions need to be reconstructed. Load information and motor condition should be considered alongside control-system records.

The condition of cables, connections, junction boxes and protective devices.
Learn more →
Compliance with the contract, design and estimate, the actual extent of the work and the cost of remedying defects.
Learn more →
Causes of failure, signs of a defect, operating conditions and the possibility of restoration.
Learn more →
Examination of melting, protective device tripping, voltage surges and appliance damage.
Learn more →
Documenting the effects of water ingress, assessing circuit condition and the need for restoration.
Learn more →
Informational letters, specialist opinions, court-appointed expert examinations and report reviews.
Learn more →Anonymized examination scenarios without information about specific participants or court decisions.

A dispute over the cause of circuit damage and the quality of earlier electrical installation work.
Learn more →
Repeated tripping of protective devices and signs of localized heating in the incoming section of the electrical panel.
Learn more →
Water entering the area of concealed wiring, sockets and a distribution board.
Learn more →This site covers electrical engineering studies, court-appointed and out-of-court expert examinations, specialist opinions and report reviews. Electrical installation work is not performed.
Attach the contract, design documentation, estimate, records and photographs, and briefly describe the purpose of your inquiry. If the form does not work, email zapros@elektrika.moscow.