Typical scenario

An RCD trips when several appliances run together

If protection trips only with several appliances operating together, the last connected appliance may be blamed. Each may work alone, while leakage currents, circuit distribution and protective-device parameters remain unrecorded.

What needs to be clarified

Check tripping conditions and distinguish contributions from appliances, fixed wiring and connections, using measurements rather than an assumption about a faulty appliance.

Materials to prepare

  • Circuit diagram, protective-device markings and as-built records
  • Appliance list with operating modes during trips
  • Earlier test reports and specialist access to the installation

What to compare

A specialist examines connections and compares protection characteristics with the actual circuit. A safe test programme assesses leakage under individual and combined loads, insulation condition and protective-device operation. Settings, switching sequence and reproducibility are recorded. Disabling protection is not used to test an explanation.

Possible outcome of the analysis

A mode-by-mode measurement table may support a technical finding or further investigation plan, with recommendations tied to the actual circuit and equipment.

Limits of the conclusions

Tripping alone does not establish that one appliance is defective. Accumulated leakage, connection errors and intermittent faults require separate checks under documented loads.

Write to usDiscuss your task ↗